3. Vnet/IP Network Configuration without using Information Network
3-7
TI 30A10A05-01E
3.3.2
Connecting Multiple Domains
n
System configuration for multiple domains
By splitting Vnet/IP stations in a system according to the operation scope and maintenance unit,
you can enable optimal management of messages in each domain. To connect the split domains,
use a layer 3 switch for each bus 1 and bus 2 of the split domains.
The following figure shows an example of how to split a Vnet/IP domain. The IP address for each
port in the recommended layer 3 switch is set by default. Therefore, to set up a system, you only
have to connect to the layer 2 switches in each domain and to those ports with the same number
as the domain number.
030302E.ai
L2SW
(Bus 1 side)
FCS0101
L2SW
(Bus 2 side)
HIS0164
Bus1:192.168.1.128
Bus2:192.168.129.128
192.168.1.2
192.168.1.3
192.168.129.2
192.168.129.3
Domain1
L3SW
(Bus 1 side)
Port1:192.168.1.253
Port2:192.168.2.253
L3SW
(Bus 2 side)
Port1:192.168.129.253
Port2:192.168.130.253
L2SW
(Bus 1 side)
L2SW
(Bus 2 side)
Domain2
HIS0264
Bus1:192.168.2.128
192.168.2.2
192.168.2.3
192.168.130.2
192.168.130.3
FCS0201
Bus2:192.168.130.128
Figure Example of system configuration for multiple domains
Aug.19,2011-00
Summary of Contents for Vnet/IP
Page 2: ...Blank Page...
Page 8: ...Blank Page...