YOKOGAWA F3LR02-0N, User Manual

Page: 88 / 210

B4-2
IM 34M06H45-01E 7th Edition : Aug.30, 2019-00
B4.2 Setting Switches
Before using this module, set its switches according to its installed location, transmission
channel configuration, etc.
Table B4.1 gives an overview of the module components and settings. Subsequent
subsections describe the setup of individual switches. For details on the location of
switches, see Section B2.4,
“Components and Their Functions.”
Table B4.1 Components and Settings
No.
1
2
3
4
5
6
7
8
Shutdown output on transmission
channel error
*2
Number of ports
Transmission channel
configuration
Not used
Distance between
stations for port 1
(Factory setting: all off)
LED
Unit number swtitch
Slot number switch
SUB UNIT
No.

LEFT SLOT
No.

RDY
ERR1
ERR2
Name Status Description
Name Description
RDY
(green)
ERR1
(red)
ERR2
(red)
Internal circuit is functioning normally.
Error: No signal in port 1. Cable discontinuity possible.*1
Normal: Input signal detected in port 2.
Number of ports is set to 1.
on
off
on
off
on
off
Hold
*3
Shutdown
Use port 1 only
Use both ports 1 and 2
Star or daisy-chain
Loop
Always off
OFF
ON
OFF
ON
OFF
ON
OFF
400
to
500 m
ON
ON
ON
ON
OFF
ON
OFF
ON
ON
OFF
ON
OFF
Unit address number setting (factory setting: 0)
Setting range:
0
: unit number when installed in main unit
1 : unit number of subunit when installed in subunit
8, 9 : cannot be used
1
Connector (port)
Condition switches
(located on side of module)
Connector for fiber-optic cable.
Remarks:
Always use port 1.
If port 2 is not used, attach it with the dust cap
(accessory)
.
Used to set first number of its base module address (factory setting: 1)
Setting range:
1,3,5,7,9,B,D,F
: valid values when using F3BU04
1,9 : valid values when using F3BU06
1 : valid value when using other base modules
(F3BU09, F3BU13, F3BU16)
OFF
OFF
OFF
OFF
2
Name State Description
1
2
3
4
5
6
7
8
FB0421.VSD
Internal circuitry is not functioning normally. No power supply.
Error: No signal in port 2. Cable discontinuity possible.*1
Normal: Input signal detected in port 1.
Distance between
stations for port 2
(Factory setting: all off)
O
F
F
O
F
F
400
to
500 m
300
to
400 m
300
to
400 m
200
to
300 m
200
to
300 m
0
to
200 m
0
to
200 m
*1:
For details on investigation of cable discontinuity, see Section B6.1, “Error Location Detection.”
*2: This setting is not valid for a master station.
*3: For a substation with secured transmission channel to the master station, continues operation if the [Subunit
Communication Error] in the [Error-time Action] group on the [Operation Control] tab of the Configuration dialog is set
to [Run].