YMGI • Your Modern Green Idea
YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!
34
Also, if you have set the TIMER ON function, and the mode for that Indoor Unit conflicts with other Indoor Units operating
when the TIMER ON function attempts to turn the system on, it will also create a Mode Conflict and shut down the Indoor
Unit.
To correct a Mode Conflict issue, turn all of the Indoor Units off, and restart them all in the same mode.
In the event a restart
doesn’t clear the error, you may need to shut power off to the entire HVAC system, wait
approximately 10 minutes and restart the system, making sure all Indoor Units are in the same Mode.
Beep
When the system is the Indoor Unit will BEEP when it receives a command from the REMOTE CONTROL.
Auto Button
Press the button when turn off the unit, the unit runs by auto mode, indoor fan motor runs under auto fan speed, turn on
swing. Press auto button under the unit is ON, it will OFF.
Auto Fan Speed Control
Under COOL, HEAT, FAN modes, the Indoor Unit fan will set the Fan speed to Hi, Medium or Low automatically based on
changes of the ambient temperature. In FAN mode the AUTO FAN speed will set to low. The fan speed will shift every 3.5
minutes
.
Sleep Function
In COOLING and FAN modes, the SLEEP function works as follows:
During the 1st Hour, the Set Temperature will be allowed to increase 1°F. In the 2nd Hour the Temperature will increase
2°F. The Indoor unit will remain at that temperature. The Temperature will not exceed 86°F even after setting the SLEEP
function.
In HEATING mode, the Set Temperature will be allowed to decrease 1°F. In the 2nd Hour the Temperature will decrease
2°F. The Indoor unit will remain at that temperature. The Temperature will not exceed 61°F even after setting the SLEEP
function.
The set temperature will not change when FAN or AUTO mode are selected, and SLEEP mode is selected.
TIMER Function
The TIMER ON/OFF function uses a 24 hour clock, so 1:00 PM will display as 13:00, 2:00 PM will display as 14:00, etc. In
order for the TIMER ON/OFF to operate correctly you will need to set the CLOCK on the REMOTE CONTROL.
CLOCK
Press the CLOCK button on your REMOTE CONTROL. The CLOCK ICON will blink. When it is blinking you can
use the TEMPERATURE INCREASE (+) or TEMPERATURE DECREASE (-) buttons to set the CLOCK to the
current time.
Once you have the clock set to the correct time, press the CLOCK button a second time. The CLOCK ICON will
stop blinking
.
TIMER ON
When the unit is OFF the REMOTE CONTROL will turn on in whichever mode you had selected when the Indoor Unit was
last running.
