YMGI • Your Modern Green Idea
YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!
38
Operation Guide
1.
After installation is complete, press "ON/OFF" button on remote controller to turn on the air conditioner.
2.
Press "MODE" button to select your required mode: AUTO, COOL, DRY, FAN, HEAT.
3.
Press " " or " " button to set
your required temperature. (Temperature can’t be adjusted under auto mode).
4.
Press "FAN" button to set your required fan speed: auto, low, medium and high speed.
5.
Press "SWING" button to select fan blowing angle
NOTICE
CHANGING BATTERIES AND NOTICES
1) Press slightly along the arrowhead direction to push the back cover open on the remote control.
2) Take out the old batteries. (As show in figure)
3) Insert two new AAA1.5V dry batteries, and pay attention to the polarity. (As show in figure)
4) Attach the back cover of wireless remote control. (As show in figure)
NOTE:
During operation, point the remote control signal sender at the receiving window on indoor unit.
The distance between signal sender and receiving window should be no more than 8m, and there should be no
obstacles between them.
Signal may be experience interference in rooms where there are fluorescent lamps or wireless telephones. The
remote controller should be kept close to indoor unit during operation.
Replace new batteries of the same model when replacement is required.
When you don’t use remote controller for a long time, please take out the batteries.
If the display on remote controller is fuzzy or there’s no display, please replace batteries.
NOTES:
When changing the batteries, do not use old or different batteries that could cause the remote control to
malfunction. Use the remote in its receiving range. Remote should be used 36 inches away from a TV set or
stereo.
If the wireless remote control cannot operate normally, please take the batteries out, wait 30 seconds and reinsert
them. If the remote still doesn’t operate normally, please replace the batteries.
If the wireless remote control will not be used for an extended period, it is recommended to remove the batteries.
Leaving the batteries in could cause them to leak. This can cause damage to the remote control.
