YMGI TTWA Series, Installation Instructions & User Manual

Page: 29 / 44

YMGI
•
Your Modern Green Idea
29
Control panel operation guide
When power is connected (stand by condition), you can operate the air conditioner by the control panel.
1. Turn ON the unit
Press the ON/OFF button to turn on the unit.
2. Adjust Set Temperature
Press the UP button to increase or the DOWN button to decrease the desired
set temperature.
3. Select Fan Speed
Press the FAN SPEED button to set your desired speed.
4. Select operation Mode
Press the MODE button to set your desired operation mode of the unit. Modes
are COOL, HEAT, and FAN
5. Energy Saver function
The default setting of the unit is operating in Energy Saving mode. The indoor
fan will continue to run for a short time after the compressor or electric heater
cycles off. You can cancel this function by pressing ENERGY SAVER button,
the green LED indicator turns off.
1. Reset Filter
means the indoor fan has been running for 250 hours accumulated. It is time
to clean the filter. After finishing cleaning, press this button to reset the time
counting.
ADVANCED SETTINGS
1. Temperature unit shift key
When unit is in standby mode (power is connected but all LEDs on the control panel are OFF), press
UP and DOWN buttons at the same time for 3 seconds, the temperature will shift between Fahrenheit
and Centigrade.
2. Temperature setting range limitation
When the unit is in standby mode, press UP and FAN SPEED buttons at the same time to enter the
maximum and minimum temperature setting range. R1~R8 will be display every 3 seconds. When
display the right range, release the two keys to save the settings. The temperature setting range is
between 60°F~90°F as factory default.
R1 R2 R3 R4 R5 R6 R7 R8
Heating Temperature Limits(°F)
86 86 90 74 92 90 72 90
Cooling Temperature Limits(°F)
63 65 72 72 67 69 68 60