YMGI
•
Your Modern Green Idea
21
2. Remove the ground screw and wire next to the grounding symbol on right side of chassis control panel
(Fig 5). Attach other end of ground wire to the hole in the bottom right side of the sleeve with #8×3/8" blunt
point sheet metal screw. The hole on the sleeve is indicated by grounding symbol on the sleeve. Slide
chassis part of the way into the sleeve and reattach the ground wire back to the hole on the right side on
the control panel area next to the ground symbol.
3. Remove shipping pads inside air conditioner next to compressor.(See Fig. B)
4.
Carefully slide the chassis into the sleeve. Ensure that the ground wire is not pinched or blew by the condenser fan.
5.
Loosen locking plate screw and rotate tab with tab behind wall case flange
(
See Fig C
)
then tighten locking plate screw
.
6. If outlet is on the left side of the unit, route power cord as shown in Fig D.
Summary of Contents for TTWA Series
