Effective Date: May 29, 2018 | 02-4001-09
Page-17
YES 45 FS/FI Storefront System
STEP 8
INSTALL SILL FLASHING END DAMS
-Hold the end dam with one hand and grab the tab with a pair of
pliers.
-Bend the end dam left or right 90 degrees in the proper
direction.
See
Details 13 & 14.
Note:
The end dam must be bent in the correct position for
the left or right end of the sill flashing.
-Clean all joint surfaces using Isopropyl Alcohol.
-Apply silicone sealant to the end of the sill flashing as
shown in
Detail 15.
-Slide the tab into the top portion of the sill flashing.
-Tap the tab into place with a small tool until the end dam is
snug against the end cut of the flashing.
-Fasten the end dam to the sill flashing with two UA-1212
screws, starting at the back, followed by the front as shown in
Detail 15.
-Tool sealant along the joint between the end dam and the sill
flashing as shown in
Detail 16.
-Seal over any exposed screw threads.
FRAME INSTALLATION
Detail 13
Detail 14
UA-1212
Sealant
Sealant
Detail 15
Detail 16
Summary of Contents for YES 45 FS
Page 2: ......
Page 35: ......
Page 36: ...YKK AP America Inc 270 Riverside Parkway Suite 100 Austell Georgia 30168 www ykkap com...
