02-4001-09 | Effective Date: May 29, 2018
Page-12
YES 45 FS/FI Storefront System
STEP 5
FABRICATE SILL MEMBERS
-For end reactions over 500 lbs., fabricate sill members for anchoring to sill flashing:
-Measure in 6” from each end of the sill member and mark hole locations along the
“V”-groove as shown in
Detail 7
.
-Mark additional hole locations a maximum of 24” on center (O.C.).
-Drill a 0.213” diameter (#3 drill bit) hole at each location marked.
-If end reaction is under 500 lbs., one (1) .213” dia. weep hole is required at the center of
each daylight opening.
See
Detail 7
.
FRAME FABRICATION
E9-1069
Sill Member
.
x
a
M
”
6
.
x
a
M
”
6
24” Max.
24” Max.
“V”-Groove
0.213” Dia.
Typical
Daylight Opening (D.L.O.)
DETAIL 7
STEP 6
FABRICATE SILL FLASHING
For elevations without door framing:
-Cut sill flashing, E9-1068 to the frame width + 1/4.
For elevations with door framing:
-Cut the sill flashing from the end of the frame to the door jamb.
(See approved shop drawings for this dimension)
See
Detail 8.
Summary of Contents for YES 45 FS
Page 2: ......
Page 35: ......
Page 36: ...YKK AP America Inc 270 Riverside Parkway Suite 100 Austell Georgia 30168 www ykkap com...
