32
main assembly
assembly
main assembly
swing the front of the top rail subassembly into
position on the front mount.
main assembly
lineup the through holes and slide the 8mm x
44mm ti Female Bolt and 8.5mmiD x 12.5mm oD washer into the
frame and rail mount.
main assembly
take the top rail sub assembly with the grease port
pointing towards the non-drive side of the frame an tap the back of
the sub assembly into the rear mount.
main assembly
line up the through holes on the frame and rail
mount and slide the 8mm x44mm solid ti Female Bolt and 8.5mmiD
x 2.5mmoD washer through the assembly. Do not attach the opposing male
bolt, the female bolt stays in this configuration only temporarily until a later
step.
19
20
17
18
main assembly
attach the Main rail subassembly to the frame with
the M5x.8x16 socket caphead bolts. tighten using a 4mm allen key.
Make sure you prep the bolts with loctite.
torque spec: 125-150 inch/pounds.
main assembly
screw the M5x.8x14 socket cap head bolts into the
frame as shown. Don not torque the bolts down, that will take place at
a later step.
main assembly
apply ti prep to the M6x1x12 ti Male Bolt. slide the
6.5mmiD x 12.5mmoD washer onto the bolt and tighten using two
5mm allen keys.
torque spec: 125-150 inch/pounds.
main assembly
place the Main rail subassembly onto the frame as
shown.
23
24
21
22
