4.2 The Enter Mode
Optionally, the Enter mode is activated with the green
Enter key
or by pressing the rotary
Selector
button arranged on its rights side. In this mode different processor functions which are independent of
the preset selection may be configured and can be accessed via a menu system (see below).
Pressing the button causes the display to show
select ACTION
in its upper line and
ESCAPE
below it.
At the same time, the LED of the Enter key will blink. Turning the Selector button calls the different
menu options in the Enter mode. Having selected the desired menu item, you may activate it by
pressing Enter again or using the Selector. Now, the selected parameter may be edited by turning the
Selector.
Note: If VIP
digital
, after an activation of the Enter mode, does not register an entry for approximately 5
seconds, the Enter mode is exited automatically and the unit is returned to the normal operating mode.
4.2.1 Assign
Preset
In the default state the first three
internal Presets
stored in VIP
digital
can be directly selected on the
front panel, using the
Preset Recall buttons
1, 2 and 3.
This function can be used to change the selection.
1) Remove a possibly inserted SmartCard
and press the Preset Recall button to which a new
preset is to be assigned.
2) Press the green Enter key or the Selector button to change to the Enter mode. The display
shows the
select ACTION
and
ESCAPE
below it.
3) Turn the Selector clockwise to call the
ASSIGN PRESET
menu item.
4) Acknowledge the selection by pressing the Enter key or the Selector.
5) Turn the Selector to select the preset which is to be assigned to the Preset Recall button
selected in 1). The corresponding LED will blink.
6) Acknowledge the assignment by pressing the newly defined Preset Recall button. The LED
will now light continuously. The upper line shows the number of the newly assigned preset, the
lower line its name.
7) Exit the Enter mode by changing to the
ESCAPE
menu item and pressing the Enter key or
simply wait until the Enter mode is exited automatically.
Note: This function may be disabled as a part of the VIP
digital
configuration. Refer to
VIP
con
– The
Configuration Software
.
Note: An Assign Preset
setting
is stored in a cap-buffered RAM for approx. 24 hrs. after the unit has
been switched off. After this time VIP
digital
will return to the default setting.
4.2.2 Meter
Mode
This menu item allows the upper
Level Indicator
to toggle between the display of the input and output
level independent from the setting loaded by the
VIP
con
configuration software
. Proceed as follows:
1) Press the green Enter button or the Selector button to change to the Enter mode. The display
shows the
select ACTION
message and
ESCAPE
below it.
2) Turn the Selector clockwise until the
METER MODE
menu item is called.
3) Acknowledge the selection by pressing the Enter key or the Selector.
4) Switch over the level instrument by turning the Selector between
Input Meter
and
Output
Meter
. The appropriate status LED below Level Indicator will light up.
5) Wait for some seconds until the Enter mode is exited, or press
ENTER
to change to a higher
level in the menu system to select another menu item.
Note: A Meter Mode
setting
is stored in a cap-buffered RAM for approx. 24 hrs. after the unit has been
switched off. After this time VIP
digital
will return to the setting loaded by
VIPcon
.
VIP
digital
Manual 4.0 Yellowtec 2004 Rev. 26.07.2004
Page 15
