4.1.5 Enter
(5)
The Enter button activates the
Enter Mode
for configuring
different processor functions independently of the presets.
Pressing the button causes the display to show
select ACTION
in its upper line and
ESCAPE
below it. At the same time, the
LED of the Enter button will blink. If no other entry is made, the
mode will be terminated after a few seconds, and VIP
digital
returns to the normal operating mode. Turning the Selector
button on the right side of the Enter button selects the different
menu options of the Enter mode. Refer to the section
Enter
Mode
for detailed information.
4.1.6 Selector
(6)
The Selector is a rotary transducer used for selecting and
setting the menu options in the
Enter Mode
. It has an additional
pressing function which is identical to the function of the Enter
key. Therefore, you may also call the Enter mode by pressing
the Selector and select menu items there in the same way.
(Refer to the
Enter Mode
).
4.1.7 Card Slot (7)
The card slot is exclusively designed for an
acceptance of the SmartCard provided for
VIP
digital
. Do not use no other storage media.
Please note that the gray double arrow of the
card points upwards as shown in the figure on the
right side, and points to the front to the unit (the
chip is on the bottom).
Note: There are no presets stored on the
YELLOWTEC SmartCard which is supplied with
the unit. Refer to Chapter
VIP
remote
– THE
REMOTE SOFTWARE
for learning how to save
data to your SmartCard.
Inserting a new SmartCard or a SmartCard with
non-valid data (e.g. data from the previous
version) will cause an error message on the
VIP
digital
display:
WRONG CARD
or
FAULTY CARD
.
When a SmartCard with valid data
is inserted in the
Card Slot
, the upper display line will show the
name of the card holder, while the name of the internal preset still active can be viewed in the lower
line. At the same time, the LED of the Exit Preset button will blink. If one of the presets on the Smart
Card is loaded by pressing the
Preset Recall button
, the lower line of the display will show the name
of the display will show the name of the card preset now activated.
Note: Use the
VIP
con
configuration software
to configure VIP
digital
for an alternative option of
SmartCard reading: Then a SmartCard preset will be activated as soon as the Card in inserted.
As another option you can disable SmartCard reading.
VIP
digital
Manual 4.0 Yellowtec 2004 Rev. 26.07.2004
Page 14
