Yeastar Technology MyPBX U520, Installation Manual

Page: 63 / 206

MyPBX U5XX Administrator's Guide
www.yeastar.com Page46
login the MyPBX User Web interface by using their extension number and
voicemail PIN # as the login and password respectively.
· Ring Out
Check this option if you want to custom the ring time. Tone will stop over the
time defined
8)
Follow me (Call Forwarding)
This function sets inbound call forwarding on an extension. An administrator can
configure FollowMe for this extension
9)
Volume Settings
Rxgain: The Volume sent to FXS extension.
Txgain: The Volume sent out by the FXS extension
10)
Mobility Extension
MyPBX allows you to use your mobile phone as extension. If you set your mobile
phone as mobility extension and then you call MyPBX with this mobility phone,
you will hear a dial tone. MyPBX will recognize your call as a call from an
extension. You can dial the number of other extensions (Your caller ID will be
the number of your extension) or dial out via outbound routes just like dialing
from your extension.
Note : If callback is enabled in the inbound route, the mobility extension
function of this inbound route will be disabled
11) Spy Settings
MyPBX allows extension to monitor/barge in other conversation. Once this
feature is enabled, the extension has the ability to monitor/barge in other calls
using the feature codes for each spy mode, refer to 'Feature Codes' page for
more information.
· spy modes
There are 4 spy modes available for choice:
General spy: you have the permission to use the following 3 modes.
Normal spy: you can only hear the call, but can't talk
Whisper spy: you can hear the call, and can talk with the monitored extension
Barge spy: you can hear the call and talk with them both
Note : for example,if 500 want to monitor extension 501, we need to enable the
'allow being spied ' for 501, and choose the spy mode for extension 500.
Then pick up 500 and dial “feature codes + 501” to start monitoring when 501
is in a call
If 500 choose „normal spy‟, it should dial‟*90501‟ to start monitoring;