11
GB
O R I G I N A L I N S T R U C T I O N S
PROPERTIES OF THE TOOL
The jigsaw is an electric tool designed for cutting of wooden surfaces and surfaces made of wood and those made of wood
derivatives, polyethylene and soft metals, using adequate blades. The tool permits easy cutting of the processed surfaces, with a
possibility of adjusting the angle. A correct, reliable and safe operation of the tool depends on its correct use, so:
Read the operating manual thoroughly before work and keep it for future reference.
The supplier shall not be held responsible for any damage occurred as a result of failure to observe safety regulations and indica-
tions contained in this manual. Using the tool for purposes it has not been designed for will make the guarantee void.
ACCESORIES
The box supplied from the factory contains the following:
- jig saw
- guide
- protection of the blade
- blade
- dust exhaust connection
TECHNICAL PARAMETERS
Parameter
Unit of measurement
Value
Catalogue number
YT-82272
Nominal voltage
[V]
~230
Nominal frequency
[Hz]
50
Nominal power
[W]
750
Nominal rotation
[min
-1
]
800 – 2800
Class of insulation
II
Maximum cutting thickness
- wood
[mm]
110
- polyethylene/polypropylene
[mm]
25
- soft metals
[mm]
10
Mass
[kg]
2,95
Level of noise:
- pressure (idling)
[dB(A)]
80,9 ± 3,0
- power (idling)
[dB(A)]
91,9 ± 3,0
Vibration (cutting of wood / metal)
[m/s
2
]
13,2 ± 1,5 / 13,8 ± 1,5
Grade of protection
IP20
GENERAL SAFETY CONDITIONS
NOTE!
Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fire or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean.
Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain inflammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fire in case of contact with inflammable gases or vapours.
Do not allow children and outsiders to the place of work.
A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fit the mains socket. Do not modify the plug. Do not use any adapters whatso-
ever in order to adapt the plug to the socket.
Unmodified plug which fits the socket reduces the risk of an electric shock.
Avoid contact with grounded surfaces, such as pipes, heaters and refrigerators.
Grounding of the body increases the risk
of an electric shock.
Do not expose electric tools to precipitation or humidity.
Water and humidity which gets into the electric tool increases the
risk of an electric shock.
