YATO YT-821023, Instruction Manual

Page: 14 / 152

14
EN
O R I G I N A L I N S T R U C T I O N S
ANGLE GRINDER OVEVIEW
The angle grinder is a power tool designed for grinding and cutting metals and mineral building materials such as brick, natural
and arti fi cial stone, concrete, glazing, etc. using abrasive discs and grinding wheels selected for a given material. Under no cir-
cumstances must the tool be used for processing materials other than those mentioned above, e.g. for grinding and cutting wood.
The correct, reliable and safe operation of the grinder requires its proper use, so before using the grinder:
Read the entire instructions manual before the fi rst use of the tool and keep it for future reference.
Always wear eye protections!
Do not use grinding discs with a maximum permissible perimeter speed of less than 80 m/s!
Do not use grinding discs with a maximum permissible rotational speed lower than the grinder’s speed.
The supplier is not liable for any damage resulting from failure to observe the safety instructions and recommendations contained
in this manual.
ANGLE GRINDER EQUIPMENT
Ginders are supplied with the following equipment:
- additional handle
- grinding disc guard
- hex wrench for fi xing the grinding disc
The equipment does not include abrasive discs.
TECHNICAL DATA
Parameter Unit Value Value
Part No. YT-821023 YT-821024
Mains voltage [V~] 230-240 230-240
Mains frequency [Hz] 50 50
Rated power [W] 1700 1700
Rated rpm [min -1 ] 10500 2850-10500
Diameter of the abrasive disc [mm] 125 125
Diameter of the abrasive disc hole [mm] 22 22
Spindle taper M14 M14
Weight [kg] 2.5 2.5
Noise level
- sound pressure L
pA
± K
pA
[dB (A)] 97.0 ± 3.0 97.0 ± 3.0
power L
wA
± K
wA
[dB (A)] 105.0 ± 3.0 105.0 ± 3.0
Vibration level
ah,AG
± K (main handle /additional handle) [m/s
2
] 4.5 ± 1.5 4.5 ± 1.5
Insulation class II II
Protection rating IPX0 IPX0
The declared noise emission value has been measured using the standard test method and can be used to compare one tool to
another. The declared noise emission value can be used in the preliminary exposure assessment.
The declared total vibration value has been measured using the standard test method and can be used to compare one tool to
another. The declared total vibration value can be used in the initial exposure assessment.
Note! The vibration emission during tool operation may di ff er from the declared value, depending on the manner the tool is used.
Note! Safety measures to protect the operator, which are based on an assessment of exposure under actual conditions of use (in-
cluding all parts of the work cycle, such as the time when the tool is switched o ff or idle and the activation time), must be speci fi ed.
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and speci fi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term “power tool” used in warnings applies to all tools driven by power both wired and wireless.