5-47
A.
Read Function (rEd)
The Read function reads the available parameter data from the drive and stores them in a EEPROM
in the digital operator. When the Read function is executed the previously stored parameter data is
cleared and replaced with newly read parameters.
5.29 COPY FUNCTION
DIGITAL OPERATOR
DESCRIPTION
KEY SEQUENCE
DISPLAY
Table 5-5. Reading Drive Parameters
Set the highest parameter
access level.
This will allow all parameters
to be viewed and set.
Press the
key until the LED
is lit on the digital operator.
DSPL
Set Parameter Copy
Access Selection (n177) = 1
Press and hold
until n177 is
displayed on the digital operator.
V
Execute upload (Read)
Using Parameter Read
Function Selection (n176)
PRGM
Then press
.
DATA
ENTER
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM
PRGM
Use the
key to set a “1” in the
display.
V
Then press
.
DATA
ENTER
Then press
.
DATA
ENTER
Press .
DATA
ENTER
Press three
times.
V
Press .
DATA
ENTER
Press the
key once.
V
Press the
key once.
V
Press . “rED” will blink on the display
while reading.
DATA
ENTER
Summary of Contents for GPD315/V7-4X
