6
7
Hotline: 1-866-902-9690
Hotline: 1-866-902-9690
Warning Symbols on the switching power supply
Before use, refer to the corresponding paragraph in the manual.
Double insulation.
Waste electrical products should not be disposed of with household waste. Recycle where
facilities exist. Check your local authority or retailer for recycling advice.
SMPS (Switch mode power supply unit) incorporating a short-circuit-proof safety isolating
switching power supply.
SMPS(Switch mode power supply unit)
Rated maximum ambient temperature 113ºF
Transfrom is for indoor use only.
Warning Symbols on battery pack
Batteries contain Li-Ion and should not be disposed with general household waste. Contact your
local authority for disposal advice.
Do not throw into water.
Do not throw on to fire.
Do not subject the battery to strong sunlight over long periods and do not leave it in high
temperatures.(max. 113ºF).
Waste electrical products should not be disposed of with household waste. Recycle where
facilities exist. Check your local authority or retailer for recycling advice.
WARNING: Cancer and Reproductive Harm-www.P65Warnings.ca.gov
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
GENERAL SAFETY WARNINGS
This machine can cause serious injuries. Follow instructions below to reduce risk of accident and injury.
IMPORTANT
READ CAREFULLY BEFORE USE
KEEP FOR FUTURE REFERENCE
PREPARATION
• Read the instructions carefully and make sure you understand them fully. Be familiar with the controls
and the proper use of the machine.
• Never allow children, persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge or people unfamiliar with these instructions use the machine.
• Local regulations may restrict the age of the operator. Children should be supervised to ensure that they
do not play with the appliance.
• The operator or user is responsible for accidents or hazards occurring to other people or their property.
• Ensure the correct installation of the perimeter boundary system as instructed.
• Periodically inspect the area where the machine is to be used and remove all stones, sticks, wires, and
other debris which could cause damage to the machine or be unsafe.
• Periodically visually inspect to see that the blades, blade bolts and cutter assembly are not worn or
damaged. Replace worn or damaged blades and bolts in sets to preserve balance.
• On multi-spindle machines, take care as rotating one blade can cause other blades to rotate.
• Never leave the machine to operate unattended, especially while other people such as children and pets
are in the area.
• Never use the machine to level out uneven patches.
• If the blades no longer cut correctly or if the motor is overloaded, check all the parts of your equipment
and replace the worn parts. If a more extensive repair is required, contact the customer service centre.
USE
• Do not put hands or feet near or under rotating parts.
• Never pick up or carry the machine while the motor is running.
• Remove the plug from the mains or remove the disabling device:
– before clearing any blockages.
– before checking, cleaning or maintaining the machine.
– after striking a foreign object to inspect the machine for damage.
– if the machine starts to vibrate abnormally, and to check for damage before restarting.
• Start Robotic Mower according to the instructions. When the main power switch is in the ON position,
make sure you keep your hands and feet away from the rotating blades.
• Never lift the Robotic Mower or carry it around with the mains switch is in the ON position.
• Do not let persons use the mower who do not know how it works or behaves.
• Do not put anything on top of the Robotic Mower or its docking station.
• Do not use the Robotic Mower with defective blade discs, body, defective blades, screws, nuts etc.
• Avoid operating the machine in wet grass. Doing so can cause additional wear and tear, and will
increase the amount of cleaning required.
SAFETY INSTRUCTIONS
SAFETY INSTRUCTIONS
WARNING
!
Ta: 113ºF
max. 113ºF