18
19
Hotline: 1-866-902-9690
Hotline: 1-866-902-9690
Press the buttons
and OK button, then close the lid, a few seconds later, Mower should automatically
return to the docking station by locating and following the boundary wire in anti- clockwise direction. If
Robotic Mower fails to dock correctly, move the docking station to a more suitable position.
1
2
Once the device has docked, "Charging" will show on the display, and the S1&S2 indicators on the docking
station will flash alternately. This indicates that the battery is charging correctly.
After initial installation, the Robotic Mower will remain in the docking station until the battery is fully charged.
Successful docking and charging indicates that you have found a suitable position for the docking station.
You should now drive fixing pegs into ground fully.
Take care not to damage or kink the surplus wire stored under the docking station.
Signal selection
Note:
the default signal is S1, no need to change the signal when there isn’t a influence signal form the
neighbors.
If your neighbour is using the same mower, you will need to keep a distance of 20 in between you and your
neighbour's boundary wires to prevent the two devices interfering with each other.
Ensure to position your docking station at least 33 ft away from your neighbour's boundary wires and that
both products are using different signals. Please refer to section "Signal setting" in order to select signal S1
or S2 for your installation.
1. Press the “signal” button on the charging station, the indicator will be switched to S2.
2. Press the "S2" button on the control panel. the indicator will be switched to S2.
>33 ft
>33 ft
>20 in
ASSEMBLY
ASSEMBLY