18
4-4. Adjusting the rotary
Adjust the rotary after attaching to the tractor.
1. Be sure that the PTO shift lever and the main gear
shift lever is at the
“
N
”
(neutral) position. Be sure
the parking brake is applied.
Start the engine.
2. Raise the rotary with the position control lever at a
height of about 10 cm and stop the engine.
3. Make the rotary level (A) with the tractor by
adjusting the right lift link [a].
4. Align the centerline of the rotary mast with the
centerline of the tractor (B) by adjusting right and
left check chains [b].
The free play (C) of right and left movement of the
rotary is about 10 mm at the top link hitch pin or
lower link hitch pin parts.
Be sure to insert the snap pin to the check chain
after adjustment.
IMPORTANT
- Do not tighten check chains too much strongly. It
may cause a breakage.
5. Start the engine and engage the PTO shift lever to
the low speed. Raise and lower the rotary slowly
with the position control lever and check a noise or
vibration on the drive shaft or the rotary.
If noise and/or vibration occur, stop the engine and
check hitching conditions of the rotary.
6. Adjust the height of skids for work.
https://tractormanualz.com/
