21
[5] Check before Work
Check the rotary before work for safety and trouble less work.
Correct a trouble if any.
Check the rotary after work too.
1. Put the tractor on a flat level place and apply the parking brake.
2. Move the reverser lever, the main gear shift lever, range shift lever and PTO shift lever to the
“
N
”
(neutral)
position.
5-1. Check procedure
1. Start the engine and set the engine speed of about 1500 rpm.
2. Move the position control lever to raise the rotary at the height of about 50 mm from the ground surface.
3. Check that a rotary is level with the ground.
4. Move the position control lever to raise the rotary at the maximum height. Check that the rotary is level
with the tractor.
WARNING
- Be sure reinstalling covers that were removed for servicing. If not, it may cause an injury accident.
CAUTION
- Move PTO gear shift lever to the neutral position and stop the engine. Be sure the rotating parts stop
completely when performing check and service.
5-2. Check points
- Conditions of the drive shaft lock pin on the PTO
shaft and the rotary pinion shaft.
- Snap pin fastening conditions.
- Tightening of tilling blade fixing bolts.
- Oil level of the rotary gear box.
- Oil level of the chain case.
IMPORTANT
- Check oil lever with rotary down on the flat place.
https://tractormanualz.com/
