34
Maintenance Method
Washing of Distiller
7.
1) Disconnect the heater lead wire from grommet.
Note that, do not bend or pull the heater lead wire more than necessary.
2) Remove the two screws of boiler securing band with a Phillips screwdriver, and take the boiler
and condenser out of the body.
Grommet
3) Loosen the knurled screws (three) and remove the boiler and condenser.
Grommet
Connecting
Hardware
Packing
Connection Port
with Condenser
Boiler
Condenser
Washing of boiler
1. Adjust detergent liquid.
1) Prepare approx. 2 liters of hot water at 50 to 60
°
C.
2) Add attached scale detergent (Orgazor) approx. 200g to hot water prepared in 1) and agitate well.
2. Seal the hose connection port at the bottom of boiler (boiler supply and drain port) by use of rubber
stopper, etc.
3. Secure the boiler at a stable position to prevent washing liquid from spilling.
4. Pour in washing liquid through connection port with condenser with heater turned on.
Most scale is removed in 4 to 5 hours approximately. Drain washing liquid in the boiler. If much scale
is distiller deposited, pour in washing liquid newly, and repeat washing
1) When scale-removing work is finished, take the heater out of boiler and wash each of them
enough with city water. Here, in washing the heater with water, be sure to fill a larger beaker with
water and wash the heater inside so that lead wire and its routing port are not wet by water.
Avoid washing the heater directly with water from tap.
2) If solid scale distiller remains after washing by washing liquid, follow the remedy below:
Boiler: Scrub with brush etc. for removing.
Heater: Scrub with something soft such as wood piece or plastic.
In this connection, remove scale on the heater uniformly in general, never leaving solid scale in part. In
an extreme case, only such part has a great heat resistance, causing damage to the heater.
