
7
2. Before using this unit
Precautions when installing the unit
Warning
6. Do not modify
7. Do not topple or tilt this unit
Modification of this unit is strictly
prohibited. This could cause a failure.
Set this unit to the flattest place. Setting this
unit on rough or slope place could cause the
vibration or noise, or cause the
unrespectable trouble or malfunction.
Spray Dryer
DL410
SI NCE 1889
OF F
ON
BL OWER
ATOM IZING AIR
3
m /min
DRYI NG AIR
BLOWE R
PUM P
KEY PANEL
OUTL ET TEM P
INL ET TEM P
INLET
TEMP
OUTLE
T TEM
P
KEY P
ANEL
PUMP
BLOWE
R
DRYIN
G AIR
m /mi
n
3
ATOMIZ
ING A
IR
BLOW
ER
ON
OFF
SI NCE
1889
DL410
Spray
Drye
r
8. Use specified receptacle for power source
Choose a correct power distribution board or receptacle that meets the unit’s rated electric
capacity.
Electric capacity: AC220V Single phase
24A
There could be the case that the unit does not run even after turning ON the power. Inspect
whether the voltage of the main power is lowered than the specified value, or whether other
device(s) uses the same power line of this unit. If the phenomena might be found, change the
power line of this unit to the other power line.
For connecting of the device to the power source, ask the dealer that you purchased this unit
from or an electrical contractor for safe.
9. Handling of power code
Do not entangle the power cord. This will cause overheating and possibly a fire.
Do not bend or twist the power cord, or apply excessive tension to it. This may cause a fire
and electrical shock.
Do not lay the power cord under a desk or chair, and do not allow it to be pinched in order to
prevent it from being damaged and to avoid a fire or electrical shock.
Keep the power cord away from any heating equipment such as a room heater. The cord's
insulation may melt and cause a fire or electrical shock.
If the power cord becomes damaged (wiring exposed, breakage, etc.), immediately turn off
the power at the rear of this unit and shut off the main supply power. Then contact your
nearest dealer for replacement of the power cord. Leaving it may cause a fire or electrical
shock.
Connect the power plug to the receptacle, which is supplied appropriate power and voltage.
Modification