Yamaha YZ 2019 Series, Owner'S Service Manual

Page: 79 / 398

CABLE ROUTING DIAGRAM
2-38
1. Battery negative lead
2. Fuel hose
3. Fuel pump coupler
4. Resistor
5. Fuel pump lead
6. Resistor coupler
7. Battery positive lead
8. Lean angle sensor
9. Starter motor lead
10.Radiator fan motor relay (blue tape)
11.Main relay (red tape)
12.Wire harness
13.Ground lead coupler
14.Starter relay coupler
15.Starter relay
16.Cross member
17.Diode
18.Fuel tank
19.Damper
20.Rear frame
21.Side cover 6
22.Plastic locking tie
A. After connecting the fuel pump coupler,
attach the coupler cover.
B. Pass the fuel hose to the front of the battery.
C. Route the resistor lead to the outside of the
leads.
D. Connect the battery positive lead to the
starter relay terminal (in the left side of the
vehicle).
E. Insert the protruding end of the wire harness
into the battery bracket hole and holder plate
hole.
F. After connecting the negative lead coupler,
place it on the right side of the battery.
G. Route the diode under the cross member and
place it on top of the rear fender.
Do not let it run onto the rib of the rear fender.
H. Lower end of the rear frame
I. Clamp it so that the lock of the plastic locking
tie faces downward, insert the end into the
rear frame and side cover 6, and then cut off
the excess end. After cutting off the excess
end, make sure that the plastic locking tie
does not protrude from the lower end of the
rear frame.
J. Clamp it so that the lock of the plastic locking
tie faces downward, and then pass the end
between the fuel hose and rear frame.
K. Clamp the wire harness at the position of the
white tape.
L. Route the battery positive lead under the
cross member.
M. After connecting the battery positive lead in
the direction indicated in the illustration, put
the cover on.