Yamaha YZ 2019 Series, Owner'S Service Manual

Page: 77 / 398

CABLE ROUTING DIAGRAM
2-36
1. Cable guide
2. Joint coupler
3. Ground lead
4. Throttle position sensor lead
5. Throttle position sensor coupler
6. Radiator breather hose
7. Cylinder head breather hose
8. Crankcase breather hose
9. Radiator hose
10.Fuel hose
11.Engine ground lead
12.Coolant temperature sensor coupler
13.Intake air pressure sensor coupler
14.Intake air temperature sensor coupler
15.Start switch coupler
16.Coupler (not used)
17.Clutch switch coupler
18.Air filter case
19.Plate
20.Bracket
A. Pass the start switch lead and clutch switch
lead through the cable guide.
B. Insert and fix the joint coupler to the plate.
After fixing it, attach the cover.
C. Pass the throttle position sensor lead to the
outside of the tension arm (the outside of the
vehicle).
D. After connecting the throttle position sensor
coupler, attach the cover.
E. Pass the radiator breather hose to the out-
side of the tension arm and the throttle posi-
tion sensor lead (the outside of the vehicle),
and to the inside of the radiator hose (the
side of the vehicle).
F. 45

G. Install the engine ground lead within a range
of 45

from a location where it will not run
over the step difference of the radiator hose
joint. Both sides of the engine ground lead
terminal can be used.
H. Attach the coupler cover to the coolant tem-
perature sensor coupler.
I. Install the ground lead terminal between the
plate and the bolt.
J. Fix the ground lead terminal to the detent in
the plate. For the ground lead terminal, either
side will do.
K. Detent