REAR BRAKE
4-32
NOTE:
Always install new brake pads, brake pad shims,
and a brake pad spring as a set.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Connect a clear plastic hose “1” tightly to the
bleed screw “2”. Put the other end of the
hose into an open container.
b. Loosen the bleed screw and push the brake
caliper piston into the brake caliper with your
finger.
c. Tighten the bleed screw.
d. Install a new brake pad shim onto each new
brake pad.
e. Install new brake pads and a new brake pad
spring.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
3. Install:
●
Brake caliper bolt “1”
4. Check:
●
Brake fluid level
Below the minimum level mark “a”
→
Add the
recommended brake fluid to the proper level.
Refer to “CHECKING THE BRAKE FLUID
LEVEL” on page 3-16.
5. Check:
●
Brake pedal operation
Soft or spongy feeling
→
Bleed the brake
system.
Refer to “BLEEDING THE HYDRAULIC
BRAKE SYSTEM” on page 3-18.
EAS22590
REMOVING THE REAR BRAKE CALIPER
NOTE:
Before disassembling the brake caliper, drain
the brake fluid from the entire brake system.
1. Remove:
●
Rear brake hose
●
Joint
●
Copper washers
NOTE:
Put the end of the brake hose into a container
and pump out the brake fluid carefully.
EAS22600
DISASSEMBLING THE REAR BRAKE
CALIPER
1. Remove:
●
Brake caliper piston
●
Dust seal “1”
●
Brake caliper piston seal “2”
Bleed screw
6 Nm (0.6 m•kg, 4.3 ft•lb)
Brake caliper bolt
17 Nm (1.7 m•kg, 12 ft•lb)
1
2
T
R
.
.
T
R
.
.
1
a
1
2
Summary of Contents for XG250
