CYLINDER HEAD
5-10
f. While holding the camshaft, temporarily
tighten the camshaft sprocket bolts.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
5. Install:
●
Timing chain tensioner
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. While lightly pressing the timing chain ten-
sioner rod by hand, turn the tensioner rod ful-
ly clockwise with a thin screwdriver “1”.
b. With the timing chain tensioner rod turned all
the way into the timing chain tensioner hous-
ing (with the thin screwdriver still installed),in-
stall the new gasket and the timing chain
tensioner “2” onto the body cylinder.
c. Tighten the timing chain tensioner bolts “3” to
the specified torque.
d. Remove the screwdriver, make sure that the
timing chain tensioner rod releases, and then
tighten the cap bolt “4” to the specified
torque.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
6. Turn:
●
Crankshaft
(several turns counterclockwise)
7. Check:
●
“I” mark “a”
Align the “I” mark on the pickup coil rotor with
the stationary pointer “b” on the crankcase
cover.
●
“I” mark “c”
Align the “I” mark on the camshaft sprocket
with the stationary pointer “d” on the cylinder
head.
Out of alignment
→
Correct.
Refer to the installation steps above.
8. Tighten:
●
Camshaft sprocket bolts
Camshaft sprocket bolt
10 Nm (1.0 m•kg, 7.2 ft•lb)
c
d
1
T
R
.
.
2
3
4
a
b
c
d
Summary of Contents for XG250
