Perio
d
ic maintenance an
d
a
d
justment
9-18
9
6. Remove the V-belt case air filter
cover by removing the bolts.
7. Remove the air filter element, and
then blow out the dirt with com-
pressed air from the clean side as
shown.
8. Check the V-belt case air filter ele-
ment for damage and replace it if
necessary.
9. Insert the element into the V-belt
case.
10. Install the V-belt case air filter cov-
er by installing the bolts.
11. Install the rear wheel sensor lead
into the holders, so that the white
tape on the lead matches the
holders as shown.
12. Install the air filter case bolts, and
then tighten the bolts to the spec-
ified torque.
1. Rear wheel sensor lead
2. Lead holder
1. V-belt case air filter cover
2. Bolt
1
2
2
1
2
2
1. V-belt case air filter element
1. Clean side
1
1
1. Rear wheel sensor lead
2. White tape
3. Lead holder
Ti
g
htenin
g
torque:
Bolt:
10 N·m (1.0 kgf·m, 7.4 lb·ft)
1
3
3
2
2
3
2
2
3
UBKA10E0.book Page 18 Thursday, September 22, 2022 1:40 PM
