Yamaha X MAX CZD300P 2022, Owner'S Manual

Page: 74 / 142

Instrument an d control functions
6-33
6
EAU14895
A d justin g the shock a b sor b er
assem b lies
WARNING
EWA10211
Always a d just b oth shock a b sor b er
assem b lies equally, otherwise poor
han d lin g an d loss of sta b ility may re-
sult.
Each shock absorber assembly is
equipped with a spring preload adjust-
ing ring.
NOTICE
ECA10102
To avoi d d ama g in g the mechanism,
d o not attempt to turn b eyon d the
maximum or minimum settin g s.
Adjust the spring preload as follows.
Turn the adjusting ring in direction (a)
to increase the spring preload.
Turn the adjusting ring in direction (b)
to decrease the spring preload.

Align the appropriate notch in the
adjusting ring with the position in-
dicator on the shock absorber.

Use the spring preload adjusting
tool included in the kit to make this
adjustment.
EAUN3820
Power outlet
WARNING
EWAN0050
To prevent electrical shock or short-
circuitin
g , install the cap when the
power outlet is not in use.
NOTICE
ECAN0210
The accessory connecte d to the
power outlet shoul d not b e use d
with the en g ine turne d off, an d the
loa d must never excee d 12 W (1 A),
otherwise the fuse may b low or the
b attery may d ischar g e.
This vehicle is equipped with a power
outlet located within storage compart-
ment A.
A 12-V accessory connected to the
power outlet can be used when the
main switch is in the “ON” position and
should only be used when the engine is
running.
To use the power outlet
1. Open storage compartment A.
(See page 4-9.)
2. Turn the main switch off.
1. Spring preload adjusting ring
2. Special wrench
3. Position indicator
Sprin g preloa d settin g :
Minimum (soft):
1
Standard:
3
Maximum (hard):
5
1
2
3
4
5
2
1 (a)
(b)
3
UBKA10E0.book Page 33 Thursday, September 22, 2022 1:40 PM