3-7
E
INSP
ADJ
CONTROL SYSTEM
2. Adjust:
• Throttle position sensor
Adjustment steps
(1) Loosen the screws
2
.
(2) Adjust the position of the throttle posi-
tion sensor until the specified output
voltage is obtained.
(3) Tighten the screws.
(4) Connect the throttle link rod.
Throttle position sensor output
voltage (pink (P) – orange (O))
0.50
±
0.02 V
3100
ADJUSTING THE REMOTE CONTROL
SHIFT CABLE
3
1. Inspect:
• Shift operation
Incorrect
→
Adjust.
2. Adjust:
• Remote control shift cable length
Adjustment steps
(1) Disconnect the shift cable joint
1
.
(2) Set the remote control lever to the
neutral position.
(3) Align the center of the set pin
a
with
the mark
b
on the bottom cowling.
(4) Adjust the position of the shift cable
joint until its hole aligns with the set
pin
c
.
(5) Install the clip
2
and tighten the lock-
nut
3
.
WARNING
The remote control cable joint must be
screwed in more than 8 mm (0.31 in).
3120
3110
