127
Basics Section
Quick Guide
Refer
ence
Appendix
Installing Optional Hardware
6
Fasten the mLAN8E to the rear cover you removed
in step
3
. Attach the unit to the cover with the
three screws you removed earlier (in step
4
). If
you start replacing the screws from the center
screw, it will be easier to replace the remaining
screws.
7
Fasten the ribbon cable on the top of mLAN8E by
using one of the tapes that came with mLAN8E.
8
Hold the mLAN8E upside down, and insert the
connector on the other end of the flat ribbon cable,
to the circuit board of the S90.
9
Re-install the cover (with the affixed mLAN8E) to
the S90.
2
1
3
Align the connectors as shown.
Underside of the S90
Rear panel of the S90
Underside of mLAN8E
Front panel of mLAN8E
Insert this in the S90’s inside.
Summary of Contents for S90
Page 136: ...136 MEMO ...