Yamaha RX10K, Assembly Manual

Page: 39 / 98

3-14
HEADLIGHT BEAM ADJUSTMENT
1. Place the machine on a level surface.
2. Place the machine from the wall at a dis-
tance
D indicated by the chart below.
3. Measure the distance from the floor to the
center of the headlight
H and place a mark
on the wall equal to distance D from the
floor.
4. With a person sitting on the machine, apply
the parking brake, start the engine and let it
idle.
5. Turn the headlight to high beam and check
the headlight projection height on the wall.
The projection should be at the parallel
mark on the wall
H to 1 / 2
_
down S from
the mark. If not, adjust the headlight angle.
D 3.0 m (10 ft.) 7.6 m (25 ft.)
S 26 mm (1.0 in.) 66 mm (2.6 in.)
D : Distance H : Height S
: Distance
6. Adjust:
S
Headlight beam (vertically)
Vertical adjustment
Higher Turn the adjusting screw
1
clockwise.
Lower Turn the adjusting screw 1
counter clockwise.