4 - 31
ENG
VALVES AND VALVE SPRINGS
4. Measure:
• margin thickness
a
Out of specification
→
Replace.
Margin thickness
0.80 ~ 1.20 mm
(0.0315 ~ 0.0472 in)
5. Measure:
• valve stem runout
Out of specification
→
Replace.
TIP:
_
• When installing a new valve, always replace
the valve guide.
• If the valve is removed or replaced, always
replace the valve stem seal.
6. Eliminate:
• carbon deposits
(from the valve face and valve seat)
7. Check:
• valve seats
Pitting/wear
→
Reface the valve seat.
Runout limit
0.040 mm (0.0016 in)
8. Measure:
• valve seat width
a
Out of specification
→
Reface the valve
seat.
▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼▼▼
a. Apply Mechanic’s blueing dye (Dykem)
b
to
the valve face.
b. Install the valve into the cylinder head.
c. Press the valve through the valve guide and
onto the valve seat to make a clear pattern.
d. Measure the valve seat width. Where the
valve seat and valve face made contact,
blueing will have been removed.
Valve seat width
1.00 ~ 1.20 mm
(0.0394 ~ 0.0472 in)
<Limit>: 1.60 mm (0.0630 in)