Yamaha N MAX GPD150-A 2015, Service Manual

Page: 206 / 450

HANDLEBAR
4-73
• The upper handlebar holders should be in-
stalled with the punch mark “b” facing forward.
3. Install:
• Handlebar weight (left) “1”
TIP
Fit the projections “a” on the handlebar weight
into the holes “b” in the handlebar.
4. Install:
• Handlebar switch (left) “1”
TIP
Align the projection “a” on the left handlebar
switch with the hole “b” in the handlebar.
5. Install:
• Rear brake master cylinder
• Rear brake master cylinder holder “1”
TIP
• Install the brake master cylinder holder with the
“UP” mark “a” facing up.
• Align the edge “b” of the brake master cylinder
holder with the edge “c” of the stay on the han-
dlebar as shown in the illustration.
• First, tighten the upper bolt, then the lower bolt.
6. Install:
• Handlebar grip “1”
• Grip end (left) “2”
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Apply a thin coat of a rubber adhesive to the
left end of the handlebar.
b. Slide the handlebar grip over the left end of
the handlebar.
TIP
Make sure that the distance “a” between the end
of the left handlebar switch and the end of the
handlebar grip is 0 mm (0 in).
c. Wipe off any excess rubber adhesive with a
clean rag.
WARNING
EWA13700
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
d. Install the left grip end.
T
R
.
.
Handlebar switch screw (left)
2.3 Nm (0.23 m·kgf, 1.7 ft·lbf)
a
2
1
3
b
b
a
a
1
1
b
b
a
1
1
b
T
R
.
.
Rear brake master cylinder hold-
er bolt
11 Nm (1.1 m·kgf, 8.0 ft·lbf)
a
c
b
1
a
1