Yamaha MTN1000 2016, Service Manual

Page: 99 / 658

CABLE ROUTING
2-54
1. Clutch cable
2. Guide
3. Front brake hose
4. Throttle cable
5. Crankshaft position sensor
6. Ignition coil #4 coupler
7. Grip cancel switch lead
8. Accelerator position sensor coupler
9. Ignition coil #3 coupler
10.Throttle servo motor coupler
11.Atmospheric pressure sensor coupler
12.Air induction system solenoid
13.Intake air pressure sensor coupler
14.Ignition coil #2 coupler
15.Air induction system solenoid coupler
16.Ignition coil #1 coupler
17.Auxiliary DC jack lead
18.Plastic locking tie
19.Front wheel sensor lead
A. Pass the wire harnesses through the guide
from the left side of the vehicle starting from
the one with the gray positioning tape first fol-
lowed by the one with the blue positioning
tape. Align the positioning tape on the wire
harness with the guide.
B. Gray tape
C. Blue tape
D. Install the wire harness clamp to the frame.
E. Yellow tape
F. Pass the wire harnesses through the guide
from the left side of the vehicle starting from
the one with the gray positioning tape first fol-
lowed by the ones with the blue and then the
yellow positioning tape. Align the positioning
tape on the wire harness with the guide.
G. Route the auxiliary DC jack lead from the out-
let of the inner panel to the inside of the
guide, and then to the inside of the air scoop.
H. To radiator fan motor
I. Fasten the brake pipe (hydraulic unit to front
brake calipers) and the protector of the front
wheel sensor lead with the plastic locking tie.
Position the plastic locking tie at the end of
the R section of the brake pipe on the outside
of the vehicle. Cut off the excess end of the
plastic locking tie to 5 mm (0.2 in) or less, and
then point the end rearward. The buckle of
the plastic locking tie may be facing upward
or downward.
J. Route the wheel sensor lead through the
claw of the bracket.
K. To front wheel sensor
L. Fasten the front wheel sensor lead at the
positioning tape with the clamp as shown in
the illustration.
M. Install the wire harness clamp to the bracket.