Yamaha MTN1000 2016, Service Manual, Page: 22 / 658

FEATURES
1-13
TCS “2”
TCS “2” provides a moderate level of traction control assist. Select this mode for standard street riding.
TCS “3”
TCS “3” maximizes traction control assist; wheel spin is most strongly controlled. Select this mode for
rain, slippery road conditions, and whenever maximum traction control is desirable.
TIP
• Use the traction control switch to change TCS settings.
•
Traction control can be turned on or off only when the vehicle is stopped.
• When the key is turned to “ON”, traction control is turned on and set to TCS “1”, “2” or “3” (whichever
was last selected).
• Turn the traction control system off to help free the rear wheel if the vehicle gets stuck in mud, sand,
or other soft surfaces.
NOTICE
ECA19650
Use only the specified tires. Using different sized tires will prevent the traction control system
from controlling tire rotation accurately.
Setting the traction control system
With the throttle closed, push traction control system switch down to change from TCS “1” or “2” to “3”.
Push up to change from TCS “3” or “2” to “1”.
With the vehicle stopped, push this switch up for two seconds to turn the system off. Push down to turn
the system on.
TIP
The current TCS setting is shown in the TCS display.
Resetting the traction control system
The traction control system will automatically disable when:
• the front wheel or rear wheel comes off the ground while riding.
•
excessive rear wheel spin is detected while riding.
• either wheel is rotated with the key turned to “ON” (such as when performing maintenance).
If the traction control system is disabled, both the “ ” indicator light and the “ ” warning light will come
on.
Should this occur, try resetting the system as follows.
1. Stop the vehicle and turn the key to “OFF”.
2. Wait a few seconds and then turn key back “ON”.
3. The “ ” indicator light should turn off and the system be enabled.
TIP
If the “ ” indicator light remains on after resetting, check the fuel injection system (Refer to “FUEL IN-
JECTION SYSTEM” on page 8-33).
4. Check the vehicle and turn off the “ ” warning light.
RES
SET
PA
SS
TCS
SELECT
2
1
1. Traction control system switch “ ”
2. TCS display