Components
27
EMU26341
Tilt support lever for power trim and
tilt model
To keep the outboard motor in the tilted up
position, lock the tilt support lever to the
clamp bracket.
NOTICE
ECM00660
Do not use the tilt support lever or knob
when trailering the boat. The outboard
motor could shake loose from the tilt sup-
port and fall. If the motor cannot be trail-
ered in the normal running position, use
an additional support device to secure it
in the tilt position.
EMU26392
Cowling lock levers
To remove the outboard motor top cowling,
pull up the front and rear cowling lock levers.
Then lift off the cowling. When the cowling,
check to be sure it fits properly in the rubber
seal. Then lock the cowling again by moving
the cowling lock levers downward.
NOTICE
ECM00550
The air intake grille on the top cowling is
not designed as a handle and could break
if used as such.
1. Trim tab
2. Bolt
3. Cap
Bolt tightening torque:
Z200 40.0 Nm (4.0 kgf-m, 29.5 ft-lb)
LZ200 42.0 Nm (4.2 kgf-m, 31 ft-lb)
A
B
ZMU01863
1. Tilt support lever
ZMU03979
1
✩✫✳✬✤✲ ✥✪
©
2019 Yamaha Motor Corporation, U.S.A.
Summary of Contents for LZ200
