Maintenance
68
ter pump will be damaged or the en-
gine will be damaged from
overheating. Before starting the en-
gine, be sure to supply water to the
cooling water passages. Avoid run-
ning the outboard motor at high
speed while on the flushing attach-
ment, otherwise overheating could
occur.
[ECM02000]
5.
Cooling system flushing is essential to
prevent the cooling system from clog-
ging up with salt, sand, or dirt. In addi-
tion, fogging/lubricating of the engine is
mandatory to prevent excessive engine
damage due to rust. Perform the flush-
ing and fogging at the same time.
WARNING! Do not touch or remove
electrical parts when starting or dur-
ing operation. Keep hands, hair, and
clothes away from the flywheel and
other rotating parts while the engine
is running.
[EWM00091]
TIP:
●
When using the flushing attachment,
maintain adequate water pressure and a
steady water flow.
●
If the overheat alert device is activated,
turn the engine off, and consult your
Yamaha dealer.
6.
Run the engine at a fast idle for a few
minutes in neutral position while supply-
ing fresh water.
7.
Just prior to turning off the engine, quick-
ly spray “Yamaha Stor-Rite Engine
Fogging Oil” alternately into the intake
silencer or the fogging hole of the silenc-
er cover, if equipped. When properly
done, the engine will smoke excessively
and almost stall.
8.
Remove the flushing attachment and
wipe off any excess water.
9.
Install the top cowling and propeller.
10. Drain the cooling water completely out
of the motor. Clean the body thoroughly.
TIP:
A flushing attachment is available from your
Yamaha dealer.
EMU28411
Lubrication (oil injection models)
1.
Install the spark plug(s) and torque to
proper specification. For information on
spark plug installation, see page 75.
2.
Fill the oil tanks. This prevents the for-
mation of condensation. For models with
a remote oil tank, it may be necessary to
manually override the control unit to
completely fill the engine oil tank.
3.
Change the gear oil. For instructions,
see page 79. Inspect the oil for the pres-
ence of water which indicates a leaky
seal. Seal replacement should be per-
formed by an authorized Yamaha dealer
prior to use.
4.
Grease all grease fittings. For further de-
tails, see page 75.
TIP:
For long-term storage, fogging the engine
with oil is recommended. Contact your
Yamaha dealer for information about fogging
oil and procedures for your engine.
1. Flushing attachment
✩✫✳✬✤✲ ✩✫
©
2019 Yamaha Motor Corporation, U.S.A.
Summary of Contents for LZ200
