En
62
Configuring the speaker settings (Speaker)
Adjust parameters for speakers manually.
■
Configuration
Adjusts the output characteristics of the speakers based on manually set parameters.
• When specifying the speaker size, set the speaker size to “Large” for each speaker with a 16 cm or larger
woofer diameter, or to “Small” for a 16 cm or smaller woofer diameter.
❏
Front
Selects the size (sound reproduction capacity) of the front speakers.
Settings
• When “Subwoofer” is set to “None,” “Large” is automatically selected.
❏
Center
Selects the size of the center speaker and whether or not to use the speaker.
Settings
❏
Surround
Selects the size of the surround speakers and whether or not to use the speakers.
Settings
❏
Subwoofer
Set whether or not to use a subwoofer.
Settings
“Phase,” “Bass Cross Over” and “Extra Bass” can be set only when “Subwoofer” is set
to “Use.”
■
Phase
Settings
• If the bass audio is lacking or unclear, the audio may be improved by changing the phase of the subwoofer.
■
Bass Cross Over
Sets the lower limit of the low-frequency component output from speakers set to “Small.”
Audio with a frequency below that limit will be produced from the subwoofer or the front
speakers.
Settings
40 Hz, 60 Hz, 80 Hz (Default), 90 Hz, 100 Hz, 110 Hz, 120 Hz, 160 Hz, 200 Hz
Large
Select this when large front speakers are connected.
Small (Default)
Select this when small front speakers are connected. The subwoofer will
produce front channel low-frequency components.
Large
Select this when a large center speaker is connected.
Small (Default)
Select this when a small center speaker is connected. The subwoofer
(or front speakers) will produce center channel low-frequency
components.
None
Select this when no center speaker is connected. The front speakers will
produce center channel audio.
Large
Select this when large surround speakers are connected.
Small (Default)
Select this when small surround speakers are connected. The
subwoofer (or front speakers) will produce surround channel low-
frequency components.
None
Select this when no surround speakers are connected. The front
speakers will produce surround channel audio signals. When set to
“None,” the sound programs will change to Virtual CINEMA DSP mode.
Use (Default)
Select this when a subwoofer is connected to the unit. During playback,
the subwoofer will produce audio from the LFE (low-frequency effect)
channel and bass audio from other channels.
None
Select this when no subwoofer is connected to the unit. The front
speakers will produce bass frequency audio.
Normal (Default)
Does not change the subwoofer phase.
Reverse
Reverses the subwoofer phase.
