Yamaha FZ6-SS 2004, Service Manual, Page: 70 / 456

2-44
CABLE ROUTING
SPEC
A Either right or left side arrangement for the left han-
dlebar switch lead coupler and radiator fan motor
coupler can be accepted.
B Point the L-shape terminal to the front side of the ve-
hicle.
C Hook the starter motor lead to the alternate pawls
on the battery cover.
D Route the crank shaft position sensor lead above
the starter motor leads.
E To the crankshaft position sensor.
F Clamp the starter motor lead and crank shaft posi-
tion sensor lead. Point the projected part of the tip to
the inner side of the vehicle.
G Pass the radiator hose, coolant reservoir hose, wire
harness and starter motor lead in order through the
lower side of the vehicle.
H Set the 4-pin coupler in the connector cover after
wiring it.
I To the sidestand switch.
J To the speed sensor.
K To the A.C. magneto.
L To the oil level gauge.
M To the rear brake/light switch.
N To the neutral switch.
O Push the wire harness in the groove of the mud
guard.
P Point the opening section of the clamp upward.
Q To the rear turn signal (right)
R To the rear turn signal (left)