Yamaha FZ6-SS 2004, Service Manual, Page: 121 / 456

3-46
A
B
BLEEDING THE HYDRAULIC BRAKE SYSTEM
CHK
ADJ
WARNING
NOTE:
NOTE:
EAS00135
BLEEDING THE HYDRAULIC BRAKE
SYSTEM
Bleed the hydraulic brake system whenev-
er:
S
the system is disassembled.
S
a brake hose is loosened, disconnected or
replaced.
S
the brake fluid level is very low.
S
brake operation is faulty.
S
Be careful not to spill any brake fluid or allow
the brake fluid reservoir to overflow.
S
When bleeding the hydraulic brake system,
make sure there is always enough brake fluid
before applying the brake. Ignoring this pre-
caution could allow air to enter the hydraulic
brake system, considerably lengthening the
bleeding procedure.
S
If bleeding is difficult, it may be necessary to let
the brake fluid settle for a few hours. Repeat
the bleeding procedure when the tiny bubbles
in the hose have disappeared.
1. Bleed:
S
hydraulic brake system
a. Fill the brake fluid reservoir to the proper lev-
el with the recommended brake fluid.
b. Install the brake fluid reservoir diaphragm.
c. Connect a clear plastic hose
1 tightly to the
bleed screw 2 .
A Front
B Rear
d. Place the other end of the hose into a con-
tainer.
e. Slowly apply the brake several times.
f. Fully pull the brake lever or fully press down
the brake pedal and hold it in position.
g. Loosen the bleed screw.
Loosening the bleed screw will release the pres-
sure and cause the brake lever to contact the
throttle grip or the brake pedal to fully extend.