Yamaha FZ6-SS 2004, Service Manual, Page: 67 / 456

2-41
A Route the throttle cables above the stay assy 1.
B Route the main switch and immobilizer lead above
the clutch cable.
C Line up the left handlebar switch lead coupler and
fan motor lead coupler behind the head pipe.
D To the immobilizer.
E To the main switch.
F Place three couplers on the flange of the cover.
G To the fuel pump.
H Clamp four wire leads. There should be no exces-
sive slack on the wire leads.
I To the engine.
J To the fuel tank.
K Either installation position can be accepted, but
make sure that the leads are not crossed.
L Clamp the rear turn signal lead and license plate
light lead to the frame. Hook the clamp to the brack-
et. Pull out the lead sufficiently to the frame side and
route it along with the side of the back stay. Cut the
tip of the clamp to be between 1 and 5 mm (0.04 and
0.20 in) upward.
M Clamp the rear turn signal lead and license plate
light lead to the frame. Cut the tip of the clamp to be
between 1 and 5 mm (0.04 and 0.20 in).
N Gap between the lead and muffler should be 10 mm
(0.39 in) or more.
O Coupler should not run on the relay assembly.
P To the tail/brake light.
Q To the license plate light.
R To the rear turn signal light. (right)
CABLE ROUTING
SPEC