–8–
B Secure the lead wire branch of
the main harness to tension pipe
1, at the immediate rear of the
gusset, by use of this clamp.
The front end of the clamp must
be directed downward.
C Clamp the four spark plug leads,
the #1 and #2 spark plug leads
up and the #3 and #4 spark plug
leads down, by use of this clamp.
Position the leading ends of the
spark plug leads near, but not
below, the lower front end of the
air induction system assembly.
SPEC
CABLE ROUTING
1
Clutch cable
2
Gusset
3
Tension pipe 1
4
Air induction system assembly
5
Spark plug lead (#2)
6
Spark plug lead (#1)
7
Starter cable
8
Air filter
9
Carburetor air vent hose
10
Air filter drain hose
11
Frame ground
12
Turn signal relay coupler
13
Carburetor heater relay coupler
14
Fuse box (for EUR)
15
Igniter unit coupler
16
Starter motor
17
Speed sensor lead
18
A.C.magneto
19
Pickup coil rotor cover
20
Oil filter cover
21
Sidestand switch
22
Sidestand switch lead
23
Horn lead
24
Ignition coil lead (#2, #3)
A Pass the wire harness and the
starter cable through the holder
wire of the gusset.
Pass the starter cable under the
wire harness.
