–7–
M Match the paint mark of the air fil-
ter drain hose to the lower end of
the guide wire.
N Make sure to pull out the hose
sufficiently so that bending does
not occur and it can be set within
this range.
O Air filter drain hose can also be
routed at the rear side (The
middle position is prohibited).
J Clump the throttle cables to the
fuel tank rail, on the tank fitting by
use of this clamp. The front end
of the clamp must be directed
downward.
K Thread this clamp through the
upper hole in the gusset and se-
cure the two throttle cables. The
front end of the clamp must be di-
rected towards the inside of the
vehicle.
L Match the marks of the fuel tank
drain hose and fuel tank breather
hose, and arrange the two types
of hose properly.
I Secure the carburetor heater
lead, starter motor cable, battery
negative lead, A.C. magneto
lead, neutral switch lead, side-
stand switch lead, pickup lead
and rear brake switch lead,
speed sensor lead (total 9
wires), to the fuel tank rail, near
the air filter intake port mounting
screw, by use of this clamp.
The front end of the clamp must
be directed towards the front of
the vehicle.
SPEC
CABLE ROUTING
