Yamaha 2004 Rhino 660 YXR660FAS, Service Manual

Page: 279 / 421

7 - 28
DRIV
REAR CONSTANT VELOCITY JOINTS, FINAL DRIVE
GEAR AND DRIVE SHAFT
Shims are supplied in the following thick-
nesses.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
Final drive pinion gear shim
Thickness (mm)
0.25 0.30 0.35
0.40 0.45 0.50
Selecting the ring gear shim
1. Select:
• ring gear shim(s)
1
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. To find the ring gear shim thickness “B”, use
the following formula.
e
= a numeral (usually a decimal number) on
the final gear case either added to “50”
f
= a numeral (usually a decimal number) on
the outside of the ring gear bearing hous-
ing and added to 1
g
= a numeral (usually a decimal number) on
the inside of the ring gear either added to
or subtracted from 35.00
h
= bearing thickness (considered constant)
Example:
1) If “98” is stamped on the final gear case,
e
= 50 + 0.98
= 50.98
2) If “55” is stamped on the ring gear bearing
housing,
f
= 1 + 0.55
= 1.55
3) If “–05” is stamped on the ring gear,
g
= 35 – 0.05
= 34.95
4)
h
= 14.00
5) Therefore, shim thickness “B” is 0.48.
“B” = 50.98 – 1.55 – (34.95 + 14.00)
= 49.43 – 48.95
= 0.48
Ring gear shim thickness
“B” =
e
–
f
– (
g
+
h
)
Bearing thickness
h
14.00 mm
f
h
e
g
“B”
1