FRONT WHEEL AND BRAKE DISCS
CHAS
6-6
NOTE:
c. Remove the brake caliper.
d. Hold the dial gauge at a right angle against
the brake disc surface.
e. Measure the deflection 2 – 3 mm below the
edge of the brake disc.
3. Measure:
brake disc thickness
1
Measure the brake disc thickness at a few
different locations.
Out of specification
Replace.
Brake disc thickness limit
(minimum)
Front: 4.5 mm
Rear: 5.5 mm
4. Adjust:
brake disc deflection
a. Remove the brake disc.
b. Rotate the brake disc by one bolt hole.
c. Install the brake disc.
Tighten the brake disc bolts in stages and in a
crisscross pattern.
Brake disc bolt
23 Nm (2.3 m
kg)
LOCTITE
d. Measure the brake disc deflection.
e. If out of specification, repeat the adjustment
steps until the brake disc deflection is within
specification.
f. If the brake disc deflection cannot be brought
within specification, replace the brake disc.
Summary of Contents for 1999 XVS1100
