4-37
NOTE:
TIMING GEARS
ENG
110 Nm (11.0 m
kg)
NOTE:
NOTE:
Front cylinder
1. Install:
(Front cylinder)
springs
1
dowel pins
timing drive gear
2
Insert the suitable pin
3
into the hole of timing
chain drive gear sprocket and match the gear
teeth.
Push the projections
a
on the timing drive
gear into the spaces
b
.
Align the punch mark
c
on the timing drive
gear, the punch mark
d
on the timing chain
drive gear sprocket and the key posision
e
as
shown.
2. Install:
claw washer
lock washer
1
New
primary drive gear nut
2
While holding the generator retor with the sheave
holder, tighten the primary drive gear nut.
3. Bend the lock washer tab along a flat side of
the nut.
Rear cylinder
When installing the rear cylinder timing gear, re-
peat the front cylinder timing gear installation
procedure. However, note the following points.
1. Install:
springs
dowel pins
timing drive gear
rotor assembly
Refer to “GENERATOR AND STARTER
CLUTCH”.
Summary of Contents for 1999 XVS1100
