Yamaha 115, Owner'S Manual

Page: 56 / 90

Operation
50
few minutes. Otherwise fuel may leak.
NOTICE
ECM00241
●
Before tilting the outboard motor, stop
the engine by following the procedure
on page 47. Never tilt the outboard mo-
tor while the engine is running. Severe
damage from overheating can result.
●
Do not tilt up the engine by pushing the
tiller handle (if equipped) because this
could break the handle.
EMU32723
Procedure for tilting up (power trim
and tilt models)
1. Place the remote control lever in neutral.
2. Press the power trim and tilt switch “ ”
(up) until the outboard motor has tilted
up completely.
3. Pull the tilt support lever toward you to
support the engine.
WARNING! After
tilting the outboard motor, be sure to
support it with the tilt support knob or
tilt support lever. Otherwise the out-
board motor could fall back down
suddenly if oil in the power trim and
tilt unit or in the power tilt unit loses
pressure.
[EWM00262]
NOTICE: Do not use
the tilt support lever or knob when
trailering the boat. The outboard mo-
tor could shake loose from the tilt
support and fall. If the motor cannot
be trailered in the normal running po-
sition, use an additional support de-
vice to secure it in the tilt position.
For more detailed information, see
page 53.
[ECM01641]
4. Models equipped with trim rods: Once
the outboard motor is supported with the
tilt support lever, press the power trim
N
ZMU03196
UP
ZMU04146
ZMU03432