6
Unpack all the parts
Control unit
A power adaptor is supplied that plugs into mains
supply wall socket and control unit. Do not plug in at
this stage, this will be done at First Time Easy Install,
section 3.
• In addition to the adapter, there is a rechargeable
battery inside the control unit that serves as a
backup in case of a power failure. A fully charged
battery can provide backup power for a period
of at least 10 hours. It takes approximately 36
hours to fully charge the battery. The control unit is
equipped with a backlit LCD display and keypad
for easy operation in dark. To conserve backup
battery duration the backlights will be switched off
during mains power failure.
Siren
The siren comes in two shapes, square shaped
and round depending on the kit purchased. The
operation and programming of the sirens are
identical, only the case is different.
2
The easiest way to get to know the system and get it up and running quickly is to get all the
devices and accessories programmed on a table top before locating and mounting them.
WARNING
The siren is very loud, be prepared! Take care not to
activate the siren tamper switch unnecessarily.
1
Remove the cover by unscrewing the single screw
located on the lid.
2
Familiarise yourself with the internal components,
do not switch siren on at this stage, this will be
done at First Time Easy Install, section 3.
PIR movement detectors
1
Pull out the plastic pull tab on the back of the PIR.
This will activate the batteries.
2
A red light can be seen flashing through the
lens. This will last for 30 seconds indicating the
component’s initiation.
