22
Adding and using Accessories
Preparation
See section 2, ‘Unpack all the parts’, for battery
insertion or activation and part identification. See
also section 1’Location planning’ and section 4
‘Installation/Mounting’ sections for installation details
and suggestions.
Adding accessories to your
system
1
From the programming menu of the control unit,
select the ‘D/-’ and press
✓
, select ‘Add
Device’ and press
✓
again.
2
Press the Learn button on the device when
prompted and confirm it is the correct detector by
pressing
✓
.
Learn buttons:
• Keyfob: Press arm
• PIR: Press the test button
• Door/Window contact: Press the test button
• Help button: Press the emergency button
• Smoke detector: Press the test button
• Keypad: Press arm. The keypad will need
initialising first, see keypad code changing and
setting below.
3
Depending on the device learnt in, finish the
programming as prompted.
Using your keyfob
• The keyfob can be used to Away Arm, Home
Arm, and Disarm the system using the buttons as
shown.
• An emergency alarm can be activated by pressing
the emergency button for 3 seconds until LED
stops flashing.
• An emergency alarm can only be stopped by using
the control unit keypad or a remote keypad.
• The system can only be disarmed after an entry or
away entry sensor is activated (in the entry period).
Keypad
Keypad code changing and setting
The keypad code is separate from the user
codes and is used to access the keypad test
(programming) mode. This will need to be changed
to preserve security. The keypad has two
operational modes, PIN code and command. The
keypad needs to be set to the PIN code mode to be
compatible with the control unit.
1
Press the ‘A’ key followed by factory default
keypad code ‘0000’.
2
The LED will now flash slowly indicating it is in test
(programming) mode.
3
Press the ‘A’ key followed by the ‘7’ key to set the
keypad into PIN code mode.
4
Press the ‘B’ key and enter new four digit keypad
code followed by the Arm key.
5
Quit test mode by pressing the disarm key twice.
The keypad code and mode setting has been
completed.
• The keypad code is not used by the system, only
the keypad itself. You should not have to use this
code again so make a note of it and keep it in a
safe, secure place.
ale
Y
R
1
2
3
6
5
4
7
8
9
0
A
B
Disarm
Home
Arm
Arm
LED
Forgotten keypad code
If the keypad code is accidentally forgotten, the
keypad can be reset to factory default using the
following steps:
1
Unscrew the two keypad case screws and remove
keypad back cover. Locate and remove the
battery.
2
Press the number ‘3’ key at the same time as
reinserting the battery.
3
Screw the keypad case together and re-learn the
keypad into the system using the steps described
above in this section.
To provide additional protection you can add extra door/window contacts, PIRs, keyfob
remote controls, keypad remote controls, help buttons and smoke detectors. These are
available separately from your local stockist.
