21
Stop the Alarm and Alarm
Display
During an alarm, the control panel and outside siren
will sound and dial the emergency phone number.
The control unit will display “ALARM! ALARM!” to
notify the user.
Stopping the Alarm
1
Press the disarm key and enter a user code on the
control unit or keypad. The control unit will sound
a long beep and display the device that caused
the alarm. The siren will beep twice and the strobe
will flash side to side.
• The keyfob cannot stop an alarm caused by
burglar or emergency device.
2
When the control unit is displaying the source
of the alarm, pressing any key will display
the telephone number that it dialled out and
acknowledged (if any). If there were more than 2
numbers that were acknowledged the numbers
will be shown by pressing further keys.
3
When “Alarm off” is displayed the system is
disarmed.
Alarm Memory
• If an alarm was raised during your absence, and
the alarm sequence has been carried out, the
screen will continuously show “ALARM! ALARM!”.
• Disarm the system as normal and the siren will
give 3-second alarm sound instead of the normal
two beeps to indicate that there might still be an
intruder still in the house.
• To clear the display, follow the same steps as
‘Stopping the Alarm’ described above.
Dialling and Call
Acknowledgement (Applicable to
Telecommunicating Kit Only)
Auto Dialling
• If the system is in away arm mode, when an alarm
occurs the control unit will immediately dial the
preset phone numbers.
• If the system is in home mode or disarmed mode
when an audible alarm is initiated, the control unit
will wait for 15 seconds before dialling the preset
phone numbers.
• After dialling, the control panel will wait 5 seconds
then playback the messages in a loop. It will first
play the recorded address message then the
pre-recorded messages (Burglar, Emergency)
depending on the nature of the alarm and finally an
acknowledgement request message.
• The recipient should acknowledge the message by
pressing ‘9’ on their telephone when prompted.
• Recipients using radio DECT phones or mobiles
should press the numbers repeatedly until the call
is closed.
• If the control unit does not receive an
acknowledgement, the messages will be repeated
for a period of 80 seconds before attempting to
dial again. Each number will have 5 call attempts.
• The control panel will continue to dial the
number(s) until a call is successfully answered with
a ‘9’ acknowledgement.
• System auto-dialling features only operate under
tone-dialling method.
• When no telephone number is stored or no
message is recorded, the control panel will not dial
out.
Remote Access
The control unit allows you to control your system
remotely through the telephone line.
1
Dial the phone number associated with the Control
panel.
2
Hang up on the first ring.
3
Wait 5-10 seconds.
4
Dial the number again.
5
The control unit will answer the phone on the first
ring of that second call.
6
Enter your PIN Code within 3 seconds.
7
If the PIN code is correct, you will hear a long
beep. A list of different functions is detailed below:
Press 2
Put the system into away armed mode (arm
the system).
Press 3
Disarm the system.
Press 5
Checking the system status. Long single
beep for Away Armed, two beeps for Disarmed and
three beeps for Home Armed.
Press 7
Siren on.
Press 8
Siren off.
Press 9 or 0
Disconnect.
• Remember to press 9 or 0 before you hang up, or
the control unit will hang up automatically after 30
seconds.
