16
2
If available select a zone type and press
✓
to
confirm.
3
After confirming the zone type (if available), you are
now asked to enter a name. Press
✓
to confirm or
P
to cancel without naming.
Device Naming
• Each device can be given a 12 character name.
Names can be given either when first adding a
device or by editing them later.
• When the “
Enter New Name
” screen is displayed
the numeric keyboard can be used to enter text.
Simply find the corresponding numeric key with
the required character and press repeatedly until
the wanted character appears. Release the key
and the flashing cursor automatically jumps to
the next position for you to continue with the next
character by the same method.
• The keys have the following functions:
1
1
2
2ABCabc
3
3DEFdef
4
4GHIghi
5
5JKLjkl
6
6MNOmno
7
7PQRSpqrs
8
8TUVtuv
9
9WXYZwxyz
0
0 <space>/&’.”+
P
Backspace and delete
• The name can be erased by clearing the display by
pressing
P
repeatedly, followed by
✓
.
4
Press
✓
when completed to confirm the name and
return to the device list.
Remove Device
To delete a device choose ‘remove device’ in the
/- menu. A list of all programmed devices
will be shown.
1
Use
ÅÇ
keys to select the device you wish to
delete and press
✓
.
2
The selected device will be displayed again, press
✓
to confirm deletion or
P
to return to the device
list without deleting.
• If a device name has not been programmed the
screen will show the preset zone number instead.
Program Siren
If an outdoor siren is to be included in the system,
this should be programmed in to the control unit.
To program the siren, select ‘program siren’ in the
/- menu. The following items are available
in this menu:
• Learn Siren
• Siren Tamp. On
• Siren Tamp. Off
• Confirm On
• Confirm Off
• Entry Snd On
• Entry Snd Off
Learn Siren
• The control unit requires that at least one device
is programmed into the system before the siren is
added.
• Put the siren into learn mode (refer to Easy First
Time Install, section 3, step 7)
• Use
ÅÇ
keys to select the “Learn Siren” menu.
• Press
✓
on the control unit.
• The control panel will give a long beep and
transmit a signal to the bell box. The bell box
should respond by activating its siren and strobe
lights momentarily when any command is sent to
it.
Siren Tamp. On, Siren Tamp. Off
The siren tamper switch can be enabled and
disabled remotely.
• The siren tamper protection automatically switches
back on after an hour.
Confirm On, Confirm Off
The siren can be enabled for arming and disarming
confirmation where one pip and flash is given for
arming, with two pips and flashes from side to side
for disarming.
Entry Snd On, Entry Snd Off
The entry and exit warning beeps can be echoed on
the siren.
Log
The alarm log memorises the last 30 system events
including:
· All alarm events with device names and type
· All fault warning events
· All arming and disarming events
• The logged events are displayed in reversed
